Power adapter product use

First of all, you need to know that the power supply to the notebook is different from the battery power supply to the notebook.

Don't suspect that there is a problem with your power supply, first check what your notebook is doing, whether it is like the two USB hard drives mentioned above, the CPU runs at full speed, the hard drive reads and writes frantically, the optical drive reads the disk at full speed, while charging the battery, playing loudly It is very important to make good use of power management and reasonably adjust the working state of the notebook according to the task.

The power supply voltage is the same, the output current is different, can it be used on the same notebook. The basic principle is that a power supply with a large nominal current can replace a power supply with a small nominal current. It is estimated that some people will think this way, thinking that a power supply with a large nominal current will burn out the notebook because the current is too large. How much current actually depends on the load for the same voltage. When the books are running at high load, the current is larger, and when the books are in standby, the current is smaller, and the power supply with a large nominal current has sufficient current margin. On the other hand, there is no problem with using a 56w power supply instead of a 72w power supply. The reason is that the design of the power adapter usually leaves a certain margin, and the load power is smaller than the power supply power, so this kind of replacement is feasible in general use. But the remaining power margin is very small. Once your notebook is connected to a lot of peripherals, such as two usb hard drives, then the cpu runs at full speed, and there is a base with an optical drive on it to read the disk at full speed, plus at the same time Charging the battery can be dangerous. Therefore, it is best not to replace the high-current power supply with a low-current power supply.

What does the nominal voltage and current of the power adapter (hereinafter referred to as the power supply) mean? First of all, the nominal voltage of the general power supply refers to the voltage of the open-circuit output, that is, the voltage when there is no external load and no current output, so it can also be understood that this voltage is the upper limit of the output voltage of the power supply.